Skip to main content
Heating, filtration and Smart Routine

Smart Spa routine is temporarily unavailable

Last updated 26 days ago

Overview

If you see the message “Smart Spa Routine is temporarily unavailable”, it usually means your in.touch system needs a firmware update before the feature can be used.

This is common for new installations and is typically resolved automatically.


Why this happens

Smart Spa Routine requires an active Gecko Premium subscription and a compatible firmware version on both in.touch modules: the Home module (EN), connected to your router, and the Spa module (CO), inside your spa's access panel.

If your system is not yet up to date:

  • The feature will be temporarily unavailable

  • You may see this message in Energy → Smart Routine

Your spa and the rest of the Gecko app keep working normally in the meantime.


What you need to do

In most cases, no action is required.

  • Firmware updates are applied automatically

  • This process can take 24 to 72 hours after setup

💡 Tip: Make sure your spa is powered on and your in.touch Home module is connected to the internet so both modules can receive updates.


Check your firmware versions

You can see the firmware version of each module in the Gecko app: ☰ menu → Settings → Devices. If the version shown for a module doesn't change after 72 hours, see When to contact support below.

Smart Spa Routine needs Spa module (CO) firmware 1.5.3 or above. The latest version is currently 1.6.4.


If you just set up your spa

This situation is completely normal for new users.

Your system needs a short period to:

  • Connect to the cloud

  • Receive the latest firmware

  • Enable all available features


Check your Gecko Premium subscription

Smart Spa Routine is part of Gecko Premium. If your subscription has ended, the routine stops and your spa stays in the Water Care mode it was in at that moment.

To turn the routine on: go to Energy → Smart Routine, then turn on the switch.

👉 How to verify your Gecko Premium subscription


When to contact support

If Smart Spa Routine is still unavailable after 72 hours:

  1. Confirm the light on your Home module is solid blue (connected).

  2. Restart both modules in this order: turn the spa off at its breaker for 15 seconds and back on, then unplug the Home module for 15 seconds and plug it back in.

  3. Allow 10 to 20 minutes, then check the versions again in Settings → Devices.

If nothing has changed, contact us through the chat in the Gecko app. Our team can check the update status of your modules from our side.