Skip to main content
Your in.touch 3

LED status reference guide - CO (Spa) module

Last updated 5 days ago

LED light meanings

LED Color / Pattern

What it Means

What to Do

Yellow (solid)

The CO (Spa Transmitter) is starting up. This appears briefly after powering on and indicates the module is loading its firmware.

Wait a few seconds. Once startup is complete, the LED will change to blue (normal operation) or start blinking slowly (not yet connected to the EN module).

Slow blinking (any color)

The CO module is not connected to the EN (Home) module. This is normal for a few seconds during startup.

Wait a few seconds. Make sure the EN (Home) module is powered on and within range. If it keeps blinking, follow the steps in My Home module blinks and never links to the spa.

Blue (solid)

Normal operation. The CO module is successfully paired and communicating with the EN (Home) module.

No action needed — your modules are working correctly.

White (solid)

A fatal error occurred during startup, preventing the CO module’s firmware from loading properly.

Restart the module by turning the spa breaker off and on. If the LED stays white, the module may need to be reprogrammed or replaced.

Red (solid)

The CO module cannot detect the spa pack. This means the communication link to the spa’s control pack is not established.

Check that the CO cable is securely connected to the spa pack’s CO port. Confirm on the spa keypad that the accessory is detected. Restart the spa. If the LED stays red, contact support for a replacement.

Red (rapid blinking)

The CO module is installing a firmware update.

Do not turn off the spa breaker during the update. If it is still blinking after several minutes, contact us in the chat.

Blue (rapid blinking)

The CO module is saving a backup of its software.

Do not turn off the spa breaker during this process. If it is still blinking after several minutes, contact us in the chat.