Skip to main content
Your in.touch 3

LED status reference guide – EN (Home) module

Last updated 2 days ago

LED light meanings

LED color or pattern

What it means

What to do

Green (solid)

The EN module is connected to your router and ready to be set up in the Gecko App.

If your spa is not in the app yet, open the app to start setup. If your spa was already set up and the light is now green, contact us in the chat. If the light changes color, check the table below for the new status.

Yellow (solid)

The module is initializing. This usually lasts a few seconds after powering on.

Wait a moment. If it stays yellow for more than a minute, unplug the power cord and reconnect it.

Red (solid)

The EN module isn’t detecting your router.

Check that your router is powered and working. Ensure the Ethernet cable is plugged in firmly at both ends. Try another cable or LAN port. If the router and cable are fine, the module may need servicing.

Red (rapid blinking)

The module is installing a firmware update.

Do not unplug or power off during the update. This usually takes under 3 minutes. If it is still blinking after that, contact us in the chat.

Blue (solid)

The module is fully connected to the internet and the Gecko cloud. It’s already linked to a user account.

Everything is working correctly. Use the Gecko App to control your spa.
⚠️ Note: Once the module is set up, it can only be used with the same account that first registered it.

Purple (solid)

The module is connected to your router but can’t reach the Gecko cloud.

Check that other devices in your home are online. If your internet works, a mesh system or your router’s security features may be blocking the connection: see Connection issue with mesh Wi-Fi systems. Then restart your router.

White (solid)

A fatal error occurred during startup.

Unplug the power cord for 10 seconds and plug it back in. If the light stays white, contact the place where you bought it.

White (slow blinking)

A critical error has occurred. The module’s identity can’t be verified.

This can’t be fixed through the app. Please contact the place where you bought it for assistance or replacement.

Slow blinking (any color except white)

The module is not connected to the CO (Spa) module. This happens on a new installation, or when the link between the two modules drops.

Check that the spa is powered on. Then give a quick single press with a paperclip in the small hole next to the module light (the light turns yellow), turn off the spa breaker, wait a few seconds, and turn it back on. Give the modules a few minutes. If they still don’t link, see My Home module blinks and never links to the spa.

Blue (rapid blinking)

The module is saving a backup of its software.

Do not unplug or turn off the module during this process. Wait 10 to 20 minutes. If it is still blinking after that, contact us in the chat.


Tips for setup and troubleshooting

  • The EN module’s LED will go through several colors when it starts or after a reset. This is normal. If it keeps cycling through colors for more than 15 minutes, plug it straight into your main router (no switch, extender or mesh unit in between) and unplug its power for 10 seconds. If it still cycles, do a factory reset: see How to factory reset the in.touch 3 EN (Home) module. If that doesn't fix it, contact the place where you bought it. For a white light, see the table above.

  • Wait for the solid green light before adding your spa in the Gecko App.

  • Keep the EN module powered and connected at all times for reliable remote access.